August 2, 2017: Believe it or not, this was actually built as a test for the next speed project (XL-175), namely a test of the arm construction and strength. However, having always wanting to build something for “normal” flying, I put a lot of thought into it and this will be my everyday flyer. The base frame is complete, but I need to order some motors…
Too many active projects, so as usual, this is a work in progress.
I have always kept this in mind on my builds, but none were practical enough. However, I decided to make a “normal” frame to fly and I ended up with a 5″ racing frame. Two versions were made. The first has 8mm tube arms. The second has 6mm tube arms. Although the 6mm arms can support me standing on the center of the frame (ends of arms being supported by 4 cans), I won’t know its true strength until I do some flying and crashing.
A Few Details
The few details I have:
- 8mm tube frame is 34g
- 6mm frame is 31g
- 210mm size frame
- Very strong (can support at least 165 lbs.)
- Lowest drag coefficient of any racing frame
Electronics I’ll be using:
- Piko Blx F3 flight controller
- Cobra Champion 2207 2450kv VEK edition
- RunCam Split
- Eachine VTX03
- Lemon rx
- Micro minimosd
- DYS 4 in 1 30A ESC
There is a downside though. As of now, there is no way of replacing a broken arm. I do not think the 8mm tube frame will ever break but I am not so sure about the 6mm. I hope to find out this week…
If by chance the 8mm arm does break, it could easily be strengthened with a 6mm tube inserted into it. This 6/8mm tube combo has proven to survive a nuclear holocaust.
Maiden Flight Videos
The first video was with DAL 5040 props, the second with Racekraft 5051’s. I had a crash on the 2nd video which knocked the camera out of alignment.
I say that a lot. I was probably going at least 60 mph when I rammed through the top of a pine tree. Actually, the quad pretty much stopped and fell while the battery flew about 150 ft. The terminal branches on a pine tree aren’t as little as the terminal branches on a deciduous tree. A branch jabbed itself into the Runcam board and apparently broke it since all I am getting is a flashing red light.
This frame is an absolute blast, but I have to make at least a couple changes:
- Protect the electronics better
- Go to 8mm arms. The 6mm arms didn’t break, but they got twisted. They are not the woven type of carbon fiber so they are weak in torsional stiffness. Once they get twisted, it pretty much loses all torsional strength.